Brizo MultiChoice T600 Serie Manual Del Usuario página 5

2 Siderna
®
A.
1
Remove plaster guard (1) from rough (2).
Note: Depending on the location of the valve
within the wall and wall thickness, an optional
extension kit (RP82245) can provide an
additional 1 3/4" of wall thickness.
C.
10
9
9
Assemble the two mounting sleeves (9) and two
mounting plates (10). Slide the mounting plate
assemblies over the trim sleeve so that the tabs/
plates (10) are at the top and bottom of the trim
sleeve, as shown. Thread screws (11) into mounting
plates just enough to assemble the two sides
together. Slide the mounting plates back against the
wall and finish tightening the screws (11).
Valve Trim Installation (T60080, T60280 & T60480)
11
10
11
60 Series Installation
B.
7
2
7
Using supplied Allen wrench, install both anti-
rotational pins (3) into holes (4) in the valve body.
USE CARE TO NOT DROP PINS BEHIND THE
WALL. It is important that the rough be mounted
in the wall as level as possible because of the
square shape of this product. Slide trim sleeve
(5) over the cartridge and bonnet aligning the two
legs (6) of the sleeve over the anti-rotational pins
(3). If the trim is not square, you can try removing
a pin and holding the sleeve secure with the two
set screws (7) provided. Make sure the sleeve is
pushed all the way back so the legs of the sleeve
rest against the valve body. The set screws (7)
should be in a position where they hit just behind
the bonnet nut (8). Tighten set screws (7).
D.
Using the mounting plates (10) as a guide, enlarge
hole around rough so that plates can be pushed up
to 1/8" into the wall. Tighten screws (11).
5
3
8
6
5
4
3
10
11
1/8"
(3 mm)
11
10
102223 Rev. B
4