Cequent Performance Products 75236 Instrucciones De Instalación

Frame Rail
Hitch Shown In Proper Position
Equipment Required: Torque Wrench
Fastener Kit: 75236F
Wrenches: 10mm, 17mm, 19mm
Drill Bits: NONE
Existing M12
Hex Washer Bolts
Both Sides
j
Conical Washer, 1/2"
Qty. (4)
k
Qty. (4) Hex Bolt, M12 x 40 x 1.25
1. CAUTION: SUPPORT THE BUMPER STRUCTURE TO KEEP IT FROM SWINGING OUT OF POSITION DURING HITCH
INSTALLATION.
2. Referring to Figure 2, remove two (2) of the existing M12 hex washer bolts from the bumper bracket as shown, and loosen the
other three (3) bolts. Do this on both sides.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2005, 2010, 2014 Cequent Performance Products – Printed in Mexico
©
Installation Instructions
Toyota Tacoma
(Does Not Fit Toyota X-Runner)
Fascia
Existing Weld Nuts
Frame
Bumper
Structure
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3, PU4
Bumper Bracket
5 Places
Both Sides
Both Sides
Figure 1
l
Qty. (4) Spacer
Sheet 1 of 6
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT
5500 Lb (2497 Kg)
5000 Lb (2270 Kg)
Accessory Rating
Remove
Remove
Figure 2
75236N 6-16-14
75236
44746
87581
Max Tongue
WT
550 Lb (250 Kg)
500 Lb (227 Kg)
C
Loosen
Rev. G