EAS ELECTRIC ECA3509 Manual De Instrucciones página 8

2.3 Don't install the unit too low, no less than 2.3
meter from the ground.
2.5 Don't allow gaps between the unit and the
wall. When hanging it from the ceiling, using the
enclosed ceiling braskets.
3、
INSTALLATION
A、
Installing on the concrete wall:
3.1.1 Removed the mounting plate
Unclamping the fixed screws on the back of
main body to removed the mounting plate.
3.1.3 When the cement has freeze, fit the
mounting plate (use the washer and nut according
to the following)
2.4 When the entrance is wider than the unit, it is
recommended to install two or more units in
parallel. In this case, provide 20-40mm gaps
between the units.
2.6 Don't install the unit in a place where it is
splashed by water, exposed to excessive steam,
explosive gas or corrosive gas.
3.1.2 Fix the bolts in the proper position (Decide the
position with the mounting plate and pour cement
into the bolt holes.)
3.1.4 Install the main body
Set the main body onto the upper end of the
mounting plate and clamp it as shown.
V1