Publicidad
Idiomas disponibles
Idiomas disponibles
1
Status
LED
3
LINE
WIRELESS SCENE CONTROLLER
FEATURES
•
The Cree Scene Controller supports on,
off, and dimming controls. See Figure
1.
•
The Cree Wireless Scene Controller
supports on, off, and dimming, and
color controls. See Figure 1.
•
The Cree Wireless Scene Controller
provides preset scene control from a
single-gang push-button wallstation.
•
Scenes may be assigned to each of the
5 buttons. See Figure 1.
•
Preset scenes may assign light levels,
color temperatures (CCT), or both.
2 of 3
Top
Button/
Button 1
Button 2
Button 3
Button 4
Button 5
GND
LINE IN
LINE TO
LOAD
SUPPLY
LEADS
INSTALLATION
NOTE: For ease of installation, Cree
recommends using a deep wall box.
STEP 1:
Disconnect power to circuit by turning circuit
breaker OFF before installation.
STEP 2:
If necessary remove existing wall plate and
switch.
STEP 3:
Strip existing wires ½". If two wires will be
connected to the same terminal on the Cree
device, both wires must be the same gauge
(12AWG or 14AWG).
STEP 4:
Wire the LINE (black), NEUTRAL (white),
and GND (green or bare) supply wires to
the corresponding pigtail leads on the Cree
device, as shown in Figure 2.
For Scene controllers with no neutral wire.
Wire the LINE IN (black) to supply wires, LINE
OUT to the switched power, and GND (green
2
NEUT
LINE
or bare) supply wires to the corresponding
pigtails on the Cree device, as shown in
Figure 3.
NOTE: If replacing an existing wall switch, the
Wireless Scene Controller shall be wired as
instructed; however, the switched power to
the load must also be tied directly to the AC
supply leads.
STEP 5:
Attach the wall plate (reference the wall plate
instruction sheet).
STEP 6:
Switch the circuit breaker ON.
STEP 7:
Press and release any button. The blue LED
should blink twice and then go off. If the
blue LED does not respond with the two-
blink sequence, please follow the RESET
instructions to return the Wireless Scene
Controller to factory defaults.
GND
LED
SUPPLY
LEADS
LPN00838X0002A0_A
Publicidad
