Warnings And Cautions; Introduction - Leviton LWCYC-00B Guia Del Usuario

WARNINGS AND CAUTIONS

• TO AVOID SHOCK OR DEATH, always connect this product to a grounded circuit.
• DO NOT operate this product if there is visible damage to the unit or cable connections.
• DO NOT operate near flammable materials - minimum 8" (20 cm) from adjacent surface.
• DO NOT expose to moisture. This product is for indoor use ONLY!
Allow product to fully acclimate to surrounding environment before connecting to a power source.
Maximum ambient temperature is 95 °F (35 °C).
• DO NOT cover the ventilation holes when operating to avoid internal overheating.
• Avoid direct eye exposure to the light source while the product is ON.
• DO NOT use if lamp shell, light barrier, lens or protection panel is damaged.
• DO NOT refit the lamp in any situation, and DO NOT install non-original components. DO NOT place any filter paper or
picture on the lamp or other optical accessories. Only the accessories approved by Leviton can be used to change the
light beam effects.
• Ensure that the bracket and hanging system can support over 10 times the weight of the fixture.
• Safety rope must be installed, meet TUV requirements and withstand 10 times the weight of the fixture.
• Ensure complete fastening of the external accessories and the sling.
• If you are unsure about any part of these instructions, consult an electrician.

INTRODUCTION

Leviton's LWCYC-00B is a professional level LED cyclorama light, with red (R), green (G), blue (B) and white (W) light sources.
LWCYC-00B achieves fine and smooth color mixing and 0 -100% flicker-free dimming control through standard DMX512
signal. Two cooling fans in the same direction as the light source ensures adequate cooling whether it is mounted upright or
hung upside down from a lighting bar. The specially designed reflector allows LWCYC-00B to cast a soft and even wash for
cyclorama and walls. LWCYC-00B supports the function of setting control parameters remotely through RDM.
Reflector
Cooling Fans
1
Yoke
Fastening
Knob
Vent Holes