Heltun HE-HT01 Guia De Inicio Rapido página 11

Including the HE-HT01 to an Existing Z-Wave Network
To add the HE-HT01 to an existing Z-Wave network (i.e. "inclusion"), do the following:
1.
Enter "SETTINGS" Mode by pressing and holding the Gear
2. Scroll menu to "Parameter 2 – nEt" using the Heating Element
3. The current state of the network will display in the Parameter Value position (upper right). It should display "EcL".
Note: If "InC" is displayed, the HE-HT01 must rst be Excluded from an existing Z-Wave network (see "Exclusion" below).
4.
Start the Inclusion Mode from the gateway/controller.
5.
On the HE-HT01 in Parameter 2, press the Plus "+" key to start the Inclusion process.
6.
Note that lines will be moving in the Parameter value position (upper right).
7.
The Antenna with signal strength bars icon
8. If only the Antenna icon
Removing the HE-HT01 from Z-Wave network
To remove the HE-HT01 from a Z-Wave network (i.e. "Exclusion"), do the following:
1. Enter "SETTINGS" Mode by pressing and holding the Gear
2.
Scroll menu to "Parameter 2 – nEt" using the Heating Element
3.
The current state of the network will be displayed in the Parameter Value position (upper right). It should display: "InC".
Note: If "EcL" is displayed, the HE-HT01 is already Excluded.
4. Start the Exclusion Mode from the gateway/controller.
5. Press the Minus "–" button in the HE-HT01 Parameter 2 to start the Exclusion process.
6. Note that lines will be moving in the Parameter value position (upper right).
7. The Antenna icon should appear in the bottom right corner and "EcL" in the value position if the Exclusion was successful.
8. If the Antenna with signal strength bars
Note: If the HE-HT01 has previously been part of a Z-Wave network and not Excluded since, Inclusion is not possible without rst
performing an Exclusion or Factory Reset procedure.
Note: If the HE-HT01 is included in the Z-Wave network the Antenna icon will appear in the bottom right corner of the main screen
with signal strength bars
should appear at the bottom right corner if Inclusion was successful.
or "Err" is displayed in the Value position, the HE-HT01 Inclusion was not successful (try repeating steps 4-7).
icon or "InC" in value position are displayed, repeat the Exclusion process.
.
button for three seconds.
button to scroll up, and the "MODE" button to scroll down.
button for three seconds.
button to scroll up, and the "MODE" button to scroll down.