Kobalt KPS 124B-03 Manual De Instrucciones página 10

OPERATING INSTRUCTIONS
3. Using with a USB
Device
When a battery pack is
installed, the USB port on the
power source supplies a 5.0V
DC, up to 3.6 Amp charging
site for your cell phone or other
small USB device.
To avoid damage to the
power source during
operation, place it on a flat
surface or secure it with the
belt hook.
a. Insert a battery pack into the power source.
b. Plug the USB cable (not provided) into one of the USB ports
(B) in the power source and plug the other end of the cable into
your device.
c. Press the ON/OFF button (A) to begin charging the USB
device.
d. The USB device will fully charge.
e. After charging is completed, if left connected with the power
source, the power source will automatically shut off after
approximately 3 hours, and the charging process will stop.
f. To reactivate the power source, press the ON/OFF button.
g. When not using or after charging, remove the USB cable and
remove the power source from the battery.
The power source is equipped with two USB ports. If the device
draws more than the rated output of the ports (Max. 2.4 A for each
port, Max. 3.6 A total both ports), the power adapter will shut off to
protect the battery pack. To reactivate the power source, remove
the device and press the ON/OFF button.
3
10