Troubleshooting - Ashley Signature Markridge Power Lift Recliner Manual De Instrucciones

The Power Button is designed to disable the power operation. It is in the cable that connects
the motor to the transformer. It is a press button. When the button is pressed to the off position,
the Green Light on the Power button will not dis play. When the button is in the on position, the
Green Light in the Power Button will display and the unit will operate.
This Class B digital device complies to part 15 of FCC rules. "Opera�on is subject to following two condi�ons: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired opera�on of the device.
INSTALLATION OF BACK-UP BATTERIES
2-9 Volt back-up ba�eries will operate the chair from the reclined
posi�on to the sea�ng posi�on one cycle in case of a power failure.
If a power failure occurs and the chair is cycled, the 2-9 volt
ba�eries will need to be replaced.
1. Remove the sliding door on the side of transformer to locate the
2-9 volt ba�eries.
2. Remove the 2-9 volt ba�eries and replace with new ba�eries.
3. Replace door on the transformer.
4. Batteries not included.
TROUBLE SHOOTING
PROBLEM
Chair will not operate
POSSIBLE FACTORS
Transformer may not be connected
SOLUTIONS
Check the transformer has been correctly connected to the socket
d
Confirm with the wire from chair to transformer is firmly connecte
May,2019
Page 3 Of 14
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved.