Greenice TB-QC25W Manual De Instrucciones página 10

Controllable distance
Type of batteries
Key number
Operating temperature
Identification
Weight
Setting up the zones
The remote for this RGBW LED strip receiver can be assigned to an unlimited number of
controllers, but one controller can only obey up to 4 remotes. To assign one or several
controllers to a single remote, follow the instructions below:
For a new kit, the remote control can only work when you program the
STEP 1.
controller. To do so, follow the steps below:
a. Properly plug in the LED controller and the LED strip/luminaire. Turn off
and on again then hold the speed up button (S+) for at least 3 seconds
until the light switches on. The light will blink twice slowly when the
controller and remote are properly set up.
*Note: If the LED does not blink twice slowly, repeat the process.
You can delete this pairing (assigning remotes to controllers) whenever
STEP 2.
necessary. The kit will return to its original state after erasing the pairing and the
controller will only respond to its corresponding controller. It may work again
when the code is reset. To do so, follow the steps below:
a. Properly plug in the LED controller and the LED strip/luminaire.
< 30 metres
2 AAA Batteries
8 touch buttons and touch colour wheel
SET (CONTROLLER + REMOTE)
-20ºC – 60ºC
CE, RoHS, ISO 9001, FC
145g (Remote) + 160g (Controller)
10