Electrical Connection - Beninca IRI.KPAD.C Manual Del Usuario

1.4) ELECTRICAL CONNECTION

STAND ALONE MODE:
NB: Having powered the device, wait 10 seconds for led switch on (device initialization).
In Fig.10 in IRI.KPAD.C the N.O. output is connected to the input in low safety voltage and OPENS a control unit, in this case
leaving Jumper JP1 open.
In Fig. 11 a support relay is used that guarantees electrical separation, in this case it is important to close the JUMPER JP1 and
comply with the maximum voltage and current values on contact indicated in Figure 10.
REMOTE MODE:
Figure 12 indicates the BE.REC receiver connection.
You can connect up to 4 IRI.KPAD.C to a single BE.REC receiver,
in this case you need to separately power the IRI.KPAD.C devices and the Jumper JP1 is irrelevant.
For all the information relating to configuration of the BE.REC receiver, refer to the instruction specifications.
2) STAND-ALONE MODE - PROGRAMMING
2.1) SAVING A CODE
1 Type the access password (123456 preset password), followed by (#).
2 Type 1.
3 Type the saving code (from 4 to 9 digits) and press (#)
4 The buzzer emits 2 beeps to confirm programming.
5 The code is now saved.
2.2) DELETING A CODE
1 Type the access password (123456 preset password), followed by (#).
2 Type 2, the buzzer emits 2 beeps.
3 Type the code to delete and press (#)
4 The buzzer emits 2 beeps to confirm deletion.
2.3) COMPLETE DELETION OF THE MEMORY
1 Type the access password (123456 preset password), followed by (#).
2 Type 9, the buzzer emits 3 beeps.
18
FAST USER'S GUIDE