CONFORM Orlo MYPLACE CSBO-1 Manual Del Usario página 7

Connecting two chairs together
– TrueWireless™ Stereo (TWS)
It is possible to connect two chairs with each
other via Bluetooth by using the TWS techno-
®
logy. This is initially done by double-clicking the
TWS button on both chairs (not needed to be
done simultaneously). Both chairs will then look
for another chair to connect to, and they will
find each other within a few seconds. You will
then hear a TWS pairing sound from each chair
and their LEDs briefly turn purple.
To connect TWS, short press the TWS button
once. To disconnect TWS, press the TWS
button for 1 second.
To avoid problems activating TWS, only play
sound in the unit you want as primary when
connecting the units.
Line-In and Line-Out
The Line-In input can be used for connecting
sound sources such as smartphones, tablets,
computer, hi-fi equipment, television sets, etc.
It is advised not to use cables longer than 3 m.
The sound coming from Line-In can also be
sent to the secondary unit via TWS.
The Line-In input is designed to be compatible
and match the signal levels from the majority of
smartphones and tablets. It should be noted,
however, that Line-Out levels vary from different
devices: levels from computers, in particular,
can be very high. This might over-saturate the
Line-In. If you connect a device to the Line-In
input and notice that the sound becomes dist-
orted at higher volumes, ensure that you lower
the volume from the sound source.
The Line-Out output is always active and can
be used for connection to other peripherals like
headphones etc.
Toggling between sound sources
If a Line-In cable is attached, you can toggle
between that and Bluetooth
PWR button.
Please note that if no Line-In cable is attached,
the button will not do anything when clicked;
nor will you be able to switch to Line-In on the
secondary unit if TWS is actively playing. This
is due to how TWS is prioritized, so either stop
playing sound on the primary unit or disconnect
TWS before switching over to Line-In.
Line-Out
Power
by pressing the
®
Line-In
ENG
7