Installation Instructions - Cadet NLW Serie Guia Del Propietario

READ ALL
INSTRUCTIONS
AND SAFETY
INFORMATION
IMPORTANT!
It is extremely
important you
verify that the
electrical supply
wires are the same
voltage as the
heater (i.e. 120 volt
heater to 120 volt
power supply and
240 volt heater
to 240 volt power
supply). If
replacing an
existing heater,
check the labels of
the old heater and
replace using the
same voltage.
Hooking a 240 volt
heater to a 120 volt
power supply will
drastically reduce
the heater's
output. Hooking a
120 volt heater to a
240 volt power sup-
ply will destroy the
heater. Connecting
your heater to an
incompatible
power supply will
void the warranty.
2

Installation Instructions

PLACEMENT: For best results install the NLW heater on an inside wall. Headers and bracing are not
necessary. NOTE: The wall can must be installed in the TOP UP position only.
THERMOSTAT: A built-in double pole thermostat is included.
How do I install for new construction?
STEP 1 Mount The Wall Can
The NLW series REQUIRES a minimum distance
of 6 inches from adjacent surfaces and 6 inches
from the floor (See Figure 4). However, Cadet
RECOMMENDS 12 inches from all adjacent
surfaces and 12 inches from the floor for longer
and cleaner performance. Heaters must be
spaced at least 3 feet apart. Secure the wall can
to the studs with four screws (not provided) as
shown in Figure 1.
FIGURE 1
FIGURE 2
Front edge of wall can
must extend
inch from face of stud
to allow for thickness
of sheetrock.
STEP 2 Route Supply Wires
Route supply wire from circuit breaker to top of wall
can. Remove knockout and attach the supply wire
with a strain relief connector, leaving 6 inches of
wire lead for later use. Connect supply ground wire
to grounding screw in wall can (See Figure 3).
Proceed to PART TWO.
SUPPLY
WIRE
KNOCK-OUT KNOCK-OUT KNOCK-OUT
(TWIST TO O (TWIST TO (TWIST T
REMOVE) REMOVE) REMOVE)
STRAIN RELIEF
CONNECTOR
FIGURE 3
Part One
How do I install in an existing wall?
STEP 1
Cut a hole 14
next to wall stud. The NLW series REQUIRES
a minimum distance of 6 inches from adjacent
surfaces and 6 inches from the floor (See Figure 4).
However, Cadet RECOMMENDS 12 inches from all
adjacent surfaces and 12 inches from the floor for
longer and cleaner performance. Heaters must be
spaced at least 3 feet apart.
FIGURE 4
STEP 2
Route supply wire from circuit breaker to top
of wall can. Remove knockout and attach the
supply wire with a strain relief connector, leaving
/ or /
1 5
2 8
6 inches of wire lead for later use. Connect
supply ground wire to grounding screw in wall
can (See Figure 3). Proceed to PART TWO.
STEP 3
Insert wall can into opening. Keeping front of
wall can flush with wall, secure to wall stud with
four screws.
STEP 4
Connect supply ground wire to grounding screw
in wall can (See Figure 3). Proceed to PART TWO.
GROUNDING GROUNDING GROUNDING
WIRE WIRE WIRE
TOP
VIEW
GROUNDING GROUNDING GROUNDING
SCREW SCREW SCREW
ALAMBRE
Cut Hole In Wall
1 / inches wide by 18 7 / inches high
8 8
1
/
4
6
6
Route Supply Wires
Mount The Wall Can
Connect Ground Wire
1 9
1
/
4