mspa MONO C-MO049 Manual Del Propietário página 22

PROBLEM
OZONATOR
FAILURE
FILTER PUMP
DOES NOT WORK
SPA LEAKING
SPA TUB IN AN
ABNORMAL
SHAPE
SPA LOOSES AIR
PRESSURE
WATER NOT
CLEAN
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
CAUSE
Water level is below the minimum
water line
One-way valve blocked
Filter pump does not work
Filter stuck by dirt or other objects
Filter system failure
Spa inlet/outlet connection not
securely tight
Drainage valve is not closed
completely
Water leaks from the spa
pool body
Extra air pressure by strong
sunlight
Air valve got loosen
Hole or split on the spa tub
Water has been used too long
Insufficient filtering
Dirty filter cartridge
Improper water maintenance
Add water above the minimum line
Contact the MSpa Service Center
Refer to "FILTER PUMP DOES NOT WORK"
section
Clean or replace the filter cartridge
Contact the MSpa Service Center
Tighten the inlet and outlet
connection
Contact the MSpa Service Center, if spa is
still leaking
Repair the leaking hole/spilt with the repair
kit material
Check the air pressure and release some air
if necessary.
During hot weather, it is recommended to
check if it is necessary to release some air to
avoid any possible damage to the spa pool
Fill up the tub with air, make sure the air
valves are secure, replace if necessary
Put soap water in a squirt bottle and spray
on seams. If there is a leak it will bubble.
After you find the leak, clean and dry the
leaking area, then use the repair patch
comes with your spa. Check the repair
section on P18
Change the water
Increase filtration frequency
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's
instruction
22
SOLUTION