Publicidad
Idiomas disponibles
Idiomas disponibles
Components
Lid handle
Power base
Operation
•
Operating voltage: 220-240V~, 50/60Hz, 2000-2400W
•
Before the first use of the kettle, clean the kettle according to the following steps: fill the kettle with water
up to the maximum water level, boil and discard, and repeat it twice.
•
This appliance's maximum capacity is 1,7 L.
•
Operation steps:
1. To fill the kettle, remove it from the power base and open the lid by pressing it together at the lid
handle and lift. Do not fill the kettle over the maximum level.
2. Make sure the lid is closed firmly before connecting to power supply. Place the kettle on the power
base and connect to power supply.
3. Press the on-/off-switch. The switch will illuminate to indicate the kettle is heating. The kettle will
switch off automatically once the water has boiled. During the process, heating can be stopped by
pressing the on-/off-switch. Press it again to continue the boiling process.
4. Lift the kettle from the power base, press the water pouring lock and pour the water.
5. The water can be kept warm by the vacuum layer between inner cavity and enclosure with no further
electricity needed (at max. water level for 2 hours ca. 80°C, for 4 hours ca. 68°C).
•
Because of safety and energy saving the appliance cannot re-start immediately after boiling. It can be
restarted only when the temperature inside is below 90°C.
•
The lid is not fully sealed in order to release steam during boiling. Therefore do not overturn the filled
kettle during transportation to avoid water spilling out.
•
The appliance is equipped with a safety function that automatically turns off the appliance when operated
without water. In this case disconnect the kettle from the power outlet and let it cool for 15 minutes
before refilling water.
Cleaning
•
Always disconnect the kettle from the power outlet before cleaning. Never immerse the kettle or power
base in water, or allow moisture to come into contact with these parts, in case of electric leakage.
•
Wipe over the exterior of the kettle with a soft wet cloth and then wipe dry with a dry cloth.
Do not use any chemicals or other abrasive cleaning solvents to clean.
•
Minerals in water may deposit at the bottom of kettle, which will influence the usability of the kettle. So
periodical descaling is needed. Please use detergents according to their instructions or vinegar.
•
For the cleaning method using vinegar fill the kettle with 3 cups of vinegar, then add water until the
maximum of the kettle and allow it to sit overnight. Empty the solution from the kettle. Fill the kettle with
clean water to the maximum level, discard after boiling. Repeat for several times until there is no taste
of vinegar left.
Lid
Spout
Body
Pouring lock
On-/Off-Switch
Handle
Publicidad
