Barrette BOM-34116407 Instrucciones De Instalación página 5

b. Insert all balusters through the square holes
in both top and bottom rails, making sure the
hole in each baluster goes in the same direction
facing the side with the two (2) small ridges (Fig. 5).
c. Make sure the balusters in the rails are about 2"
above the rail and in-line with each other (Fig. 5).
d. Snap in bumps from locking strip into holes of
the baluster for both top and bottom rails. Make
sure arrows on locking strip face rails (Fig. 6).
Arrows will point towards each other during
assembly. Run your fingers along both the rails
to ensure locking strip is fully engaged prior
to moving on to Step 3. Strips must be fully
engaged to lock balusters in place.
e. If the rails were cut shorter in step 1, then there
will be some extra locking strip at the end of
install. Use scissors or a utility knife to trim off
the excess, while leaving approximately 2" after
the last engaged bump.
f. Pull the top and bottom rails towards ends,
guiding the rails over the locking strips until
snug.
g. Stand rail section up and fully lock balusters into
the rails. Place one foot on the top of the bottom
rail, between the second and third baluster
while at the same time placing a hand under the
bottom of the top rail between the second and
third baluster. Push with foot and pull with hand
until locking is completed. You should hear a
snap as the strip locks into the rail. Repeat this
process for the middle and the end of the panel
(Fig. 7 & 8).
NOTE:
3.
Install Support Block:
Pivot support block in place under the rail (Fig. 9).
NOTE:
Secure support block to the mounting surface
using 1
into place using plastic plug (Fig. 10).
If no snap is heard or felt, use a rubber
mallet to tap underneath of top rail to ensure
a full connection.
⁄ " screw(s) provided and press cover
1
2
2" 2"
Two Small Two Small
Ridges Side Ridges Side
Arrows Arrows
Pointing Down Pointing Down
Side Views of Rails Side Views of Rails
and Locking Strips and Locking Strips
Fig. 5
Two Large Two Large
Ridges Side Ridges Side
Fig. 6
Fig. 7
Locked
Fig. 8
Fig. 9
Fig. 10
5