Installing The Appliance; Fitting The Appliance - Infiniton 1040YA1 Manual De Instrucciones

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since
they can scratch the surface, which may result in shattering of the glass.
Steam cleaner is not to be used.
WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.
This appliance is for house hold use only.

INSTALLING THE APPLIANCE

Important: Unplug your oven before performing installation or maintenance!
Installation should be carried out according to the instructions by a professionally qualified
person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to a
wrong installation.

FITTING THE APPLIANCE

Fit the appliance into its surround (beneath a
work-top or above another appliance) by inserting screws into the 4 holes that can be seen in the
frame of the oven when the door is open.
For the most efficient air circulation, the oven should be fitted according to the dimensions shown
in fig. 1-2.
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which
the oven is fitted should have a gap of at least 70 mm at the rear.
NB: where ovens are to be matched with hobs, it is essential to follow the instructions
contained in the booklet supplied with the other appliance.
IMPROTANT
During use the appliance becomes hot, Care should be taken to avoid touching heating
elements inside the oven.
Accessible parts may become hot during use. Yong children should be kept away.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since
they can scratch the surface, which may result in shattering of the glass.
For a built-in oven to work well the cabinet must be of the right type.
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature of
120℃. Plastic materials or adhesive which cannot withstand this temperature will become
deformed or unstuck.
To comply with safety regulations, once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
All parts which offer protection should be fixed in such a way that they cannot be removed