Haier QWR04D R Serie Instrucciones De Instalación Y Manual Del Usuario página 16

TROUBLE SHOOTING
PROBLEM
Appliance does not
operate
Vibration or rattling
(slight vibration is
normal)
Motor operates for long
periods or cycles on and
off frequently
Compartment too warm
Appliance has odor
Door not closing
properly
16
POSSIBLE CAUSES
Appliance may be in defrost cycle.
Appliance is unplugged.
Appliance is powered off.
The circuit breaker is tripped/ he fuse
is blown.
GFI outlet is tripped.
Appliance is on an uneven surface.
Normal when appliance is first
plugged in.
Often occurs when large amounts of
wine or beverages are placed in the
appliance.
Door left open.
Hot weather or frequent door
openings.
Temperature control set at the
coldest setting.
Normal when appliance is first
plugged in.
Often occurs when large amounts of
wine or beverages are placed in the
appliance.
Temperature control not set cold
enough.
Warm weather or frequent door
openings.
Door left open.
Interior needs cleaning.
Door gasket is sticking or folding
over.
The door is hitting an internal
component inside the appliance.
WHAT TO DO
This is normal. Compressor does not operate for at least 40
minutes when in defrost cycle.
Push the plug completely into the outlet.
Power appliance back on. See "Power" in Temperature Control
section.
Replace fuse or reset the breaker.
Reset outlet.
Adjust the leveling legs as shown in the Installation Instructions.
Wait 24 hours for the appliance to completely cool down.
This is normal.
Always make sure that the door is closed after opening.
Check to see if a bottle is holding door open.
This is normal.
Allow 24 hours for temperature to change.
Wait 24 hours for the appliance to completely cool down.
This is normal.
See Temperature Control section.
See Temperature Control section.
Always make sure that the door is closed after opening.
Check to see if a bottle is holding door open.
See Care and cleaning.
Keep open box of baking soda in appliance; replace every 3
months.
Apply petroleum jelly or paraffin wax to the face of the gasket.
Adjust internal components to prevent interference.
49-1000564 Rev. 0