HANGING YOUR FIXTURE
1. Make sure your unit is unplugged.
2. Hang the fixture from a strong cord or chain from both ends. Make sure you have hooks solidly screwed into
the studs in the ceiling. If you cannot locate the studs, insert expansion anchors into the ceiling. The hooks
should be rated to hold at least 50 lbs each.
TIPS
•
The lamp may require 10-30 minutes cooling time before restarting.
•
After you plug the reflector in, the bulb may require several minutes to reach its full brightness. In the event of
a momentary power interruption, the bulb will not restart immediately.
•
Some variation in the color of light emitted by the bulb is not unusual, especially in the first 100 hours of
operation.
•
Never pull the cord to unplug the reflector, pull the plug only.
•
Avoid scratching the bulb, subjecting it to undue pressure, or getting it wet when it is hot; these actions may
cause the bulb to break.
•
In the event of bulb breakage, immediately unplug the reflector to prevent exposure to ultraviolet energy,
which may be harmful to eyes and skin.
•
Keep room temperature below 950F, with adequate air circulation by fan in the growing area.
•
The DE lamp produces very high-intensity light and was originally designed for commercial
growing operations. Please take care to consider proximity to plants when installing your fixture. You may want
to allow more vertical space between the plant canopy and the fixture to mitigate the high-intensity light and
heat in the plant area.
•
Always use a heavy-duty 3-pronged grounded timer, rated for at least 15 amps. Many 7-day digital timers are
not rate for 1000W lamps.
•
Unplug ballast when changing or removing the lamp. Failure to do so can cause ballast failure or improper
diagnosis.
PARTS LIST
1- Phantom DE Open Reflector
1- Hanging hardware kit
1- Instructions
LIMITED WARRANTY
Hydrofarm warrants this reflector to be free from defects in materials and workmanship. The warranty term is
1-year beginning on the date of purchase. Misuse, abuse, or failure to follow instructions is not covered under
this warranty, nor is damage caused by failure to properly install the lamp according to these instructions. This
warranty also does not cover any labor associated with installation or removal of the reflector. Hydrofarm will,
at our discretion, repair or replace the reflector covered under this warranty if it is returned to the original place
of purchase. To request warranty service, please return the reflector, with original sales receipt and packaging,
to your place of purchase. The purchase date is based on your original sales receipt. For more detailed warranty
information, visit our website.
4
SPECIFICATIONS
Relamp with 1000 watts
Type K12x30s
400V HPS lamp
parsource.com
hydrofarm.com