Make Electrical Connection - Samsung NZ24T4360RK Manual De Instalación

Installation instructions
STEP 2-1 Installing the bracket guide
The bracket Guide can be installed after cooktop is placed into the cutout.
Bottom of Cooktop
M4L10
M4L16 screw
screw
STEP 2-2 Alternative Bracket Guide Installing
Countertop
M4L75 screw
M4L10 screw
Cooktop
8 English
Install_NZ24T4360RK_EN.indd 8
1. On the bottom of the cooktop, find the
holes where the bracket guide attaches.
(Refer to the figure.)
2. Place the bracket guide onto the hole,
and then move it towards the sidewall
of the cabinet until it touches the
sidewall.
3. Use the screws to fasten the bracket
guide to the cooktop and the sidewall.
NOTE
• Make sure you attach the bracket guides
on the left and right side.
• Make sure that the front edge of the
cooktop is parallel to the front edge of the
countertop. If repositioning is needed, lift
entire cooktop up from cutout to avoid
scratching the countertop.
1. Attach bracket guide to bottom and
select bracket location.
2. Tighten screw bracket guide to base of
cooktop.
3. Install M4L75 screw until bracket
touches the bottom of the countertop.

Make electrical connection

This cooktop is manufactured with ground wire (bare or green) connected to the
cooktop frame. Connect the cooktop cable to the junction box through the UL
listed or CSA approved conduit connector.
Electrical Connection Options
If your home has: And you will be connecting to :
4-wire direct
A fused disconnect or circuit
breaker box
3-wire direct
A fused disconnect or circuit
breaker box
Go to section:
4-Wire Cable from Power
supply to 3-Wire Cable
from Cooktop
3-Wire Cable from Power
supply to 3-Wire Cable
from Cooktop
2020-06-18 12:05:34