OutBack Power GTFX Serie Manual De Programación página 40

3. After powering up the components, connect the MATE to the HUB.
a) Plug the MATE into the 1st MATE Port on the HUB.
b) The MATE will power up and should recognize any component connected to the HUB.
c) The MATE can then program the FXs.
d) The fifth MATE screen ("Port Assignment") should display all the FXs and any OutBack Charge Controllers in
the system.
MATE Screens
PATH
g'day mate (C) 2008
OutBack
Power
4. To verify the MATE recognizes each HUB connected FX and OutBack Charge Controller, disconnect and then
either (a) reconnect the MATE to view its boot-up and repoll sequence or (b) follow this path to manually repoll:
PATH
mAIN-------------------
12.15:30p
Sum STATuS SETuP ADv
The FXs are now ready to be programmed according to the stacking options described in the next
section.
38
version
Code a.aa
Systems Serial #xxxxxxxx
Screen EE b.bb
SETuP----------------- SETuP/mATE/PAgE1
mate code rev: 4.1.6
choose device: choose category:
FX mATE CLOCk CNT gLOw Pg2
Searching Port Assignment
for Devices 1> FX 2> FX 3> CC 4> CC
5>
HuB Found 9>
SETuP/mATE/PAgE2
choose category:
Pg1 Sumry COmm mAIN
6> 7> 8>
10> 2m>
SETuP/mATE/COmm
choose category:
BACk rEPOLL PC DEBug