Publicidad
Enlaces rápidos
™
2.7-GALLON PNEUMATIC PUMP FLUID
EXTRACTOR USER'S MANUAL
Part No. JDI-172EV
READ AND SAVE THIS MANUAL
LEA Y GUARDE ESTE MANUAL
LISEZ ET CONSERVEZ CE MANUEL
FOR SERVICE ASSISTANCE, CALL 800-433-0708 OR VISIT JOHNDOW.COM
PARA OBTENER ASISTENCIA DE SERVICIO, LLAME AL 800-433-0708 O VISITE JOHNDOW.COM
POUR UNE ASSISTANCE DE SERVICE, APPELEZ LE 800-433-0708 OU CONSULTEZ JOHNDOW.COM
02425 68845
6
2
151 Snyder Ave.
Barberton, OH 44203
Rev 3/2021
Publicidad
Manuales relacionados para JohnDow Industries JDI-172EV
Resumen de contenidos para JohnDow Industries JDI-172EV
- Página 1 ™ 2.7-GALLON PNEUMATIC PUMP FLUID EXTRACTOR USER’S MANUAL Part No. JDI-172EV READ AND SAVE THIS MANUAL LEA Y GUARDE ESTE MANUAL LISEZ ET CONSERVEZ CE MANUEL FOR SERVICE ASSISTANCE, CALL 800-433-0708 OR VISIT JOHNDOW.COM PARA OBTENER ASISTENCIA DE SERVICIO, LLAME AL 800-433-0708 O VISITE JOHNDOW.COM POUR UNE ASSISTANCE DE SERVICE, APPELEZ LE 800-433-0708 OU CONSULTEZ JOHNDOW.COM...
- Página 2 WARNING / ADVERTENCIAS / AVERTISSEMENT Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. 1. For safety reasons, DO NOT use the unit to extract or store gasoline or other highly flammable liquids. 2. DO NOT use the unit to extract, siphon or store dangerous chemicals, poisons, acids alkalis, solvents or any flammable products. If these liquids were used in the unit, immediately drain, wash and thoroughly clean. 3. If the unit was used to extract salt water, eg. Bilge water, thoroughly flush and wash the unit with fresh, clean water. 4. The unit is not designed for long term storage of oil, or other fluids. The used oil must be poured in to a suitable container and disposed of in an appropriate manner. 5. DO NOT store either the unit or suction tubes near open flames, in areas of high temperatures, direct sunlight, rain or snow. 6. DO NOT dismantle, tamper with or adapt the unit for any other purpose than what it was originally intend- ed for. 7. DO NOT drop, throw or misuse the unit. 8. If you accidentally overfill the reservoir, turn OFF the air inlet valve immediately to avoid leaking.
- Página 3 OPERATING INSTRUCTIONS / INSTRUCCIONES DE USO / MODE D'EMPLOI 1. Remove the oil dipstick. 1. Retire la varilla de medición de aceite. 1. Retirez la jauge d’huile. 2. Select and insert the appropriate diameter extracting tube into the dip- stick until it reaches the bottom of the oil pan, connect the main suction tube to the unit and to the extracting tube. 2. Seleccione e inserte el tubo de extracción de diámetro apropiado en la varilla de medición hasta que llegue al fondo del cárter de aceite, conecte el tubo de succión principal a la unidad y al tubo de extradición.