CREE LIGHTING Noctura Serie Instrucciones De Instalación

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3. Suitable for wet locations.
Convient aux emplacements mouilles
4. Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant pas 40°C.
5. Suitable for mounting within 1.2M (4ft) of the ground.
Peut etre installe a moins de 1,2 m (4 pi) du sol.
6. Class 1 wiring only.
Cablage de classe 1 uniquement.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1
(2) Screws
MOUNTING OVER RECESSED JUNCTION BOX
STEP 1:
Loosen the two screws on the right side of luminaire to allow luminaire
to hinge open. See Figure 1.
STEP 2:
Remove luminaire housing from hinge pins by sliding luminaire off of
pins. Set the luminaire housing aside.
STEP 3:
Remove knockouts in four corners of back box with a hammer and punch.
STEP 4:
Remove appropriate knockouts for junction box being used. See Figure 2
for knockouts corresponding to various junction box styles.
1 of 3
IMPORTANT SAFEGUARDS
2
4
3
Center Grommet
5
1 2
STEP 5:
Feed supply leads from junction box into the back box through hole in the
center grommet on the back wall of the back box.
STEP 6:
Attach back box to junction box using hardware supplied by others. Make
sure the back box is positioned with exposed portions of the hinge pins
pointing up. Four additional fasteners, appropriate for the mounting
surface, should be inserted through the holes opened in Step 3 and into
mounting surface. This will securely attach the back box to the mounting
surface. The bubble level on the back box should be used to make sure
the back box is properly leveled. See Figure 3.
NOTE: To ensure a watertight seal, a high grade caulking material, such
as silicone rubber, should be used between the back gasket and the
mounting surface.
Noctura Series
LED Wall Pack
Large Wall Pack
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
6, 7
1, 2, 3
4, 5
6
7 7
LPN00628X0002A0_B