Publicidad
9
8
7
6
1. LIMIT INDICATOR: The Limit Indicator will blink on occasion when the built-in limiter is active.
NOTE: If the indicator glows or starts to blink frequently, you should turn down the level (3).
2. SIGNAL INDICATOR:The Signal Indicator will glow when there is a signal received to the
input connectors (8)
3. Subwoofer Gain Control :This knob is used to regulate the output level of the subwoofer.
Use this to set the balance between the speakers and subwoofers.
4. PROTECT INDICATOR :The PROTECT INDICATOR will begin to glow when the subwoofer goes
into protect mode.Protect mode prevents the subwoofer amplifier.
the subwoofer goes into protect mode all output will stop. This is to protect the subwoofer and
any speakers connected to subwoofer.
5. POWER LED :This LED will be lit when the power is ON.
6. High Pass XLR Output :These outputs are used to send signal over 120 Hz to feed a mid/high
active speaker or power amp.
7. Phase Switch :The PHASE SWITCH reverses the polarity of the subwoofer.This switch depends
on the placement of the subwoofer relative to the speaker.
8. Full Range XLR Input :These connections are designed to accept a line signal from a mixer or
other line level device with a balanced output .
9. Thru(Full Range Output) :These output are used to send the signal from the FULL RANGE
INPUTS to another device.
AS Series (Active/Pasive)
AS 600PW
- 4 -
User manual /Manual de Usuario
1
2
3
4
5
Publicidad
