Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Attach the driver side front Support Bracket to the Nut Plate with (1) 10mm x 30mm Hex Bolt, (1) 10mm Lock
10mm x 30mm Hex Bolt
(2) 10mm Flat Washers
10mm Lock Washer
10mm Hex Nut
1500 Models:
Attach the bent end of the Front Support Bracket to the outside hole in the Front Mounting Bracket with (1) 10mm x 30mm Hex Bolt, (2) 10mm
Flat Washers, (1) 10mm Lock Washer and (1) 10mm Hex Nut, (Figure 3). Do not tighten at this time.
Up to 2010 25-3500 Models-Support Bracket not required on 2011-14 25-3500 Models:
Note that the Front Support Bracket will not reach up to the Mounting Bracket, (Figures 3 & 4). Tighten the Support Bracket to the Nut Plate in the
frame. Carefully push up on the Support Bracket until it reaches the inside hole in the Mounting Bracket, (Figure 4). Bolt the Support Bracket to the
hole in the Mounting Bracket with (1) 10mm x 30mm Hex Bolt, (2) 10mm Flat Washers, (1) 10mm Lock Washer and (1) 10mm Hex Nut. Do not
4
tighten at this time.
All 1500 and up to 2010 25-3500 Models-Support Bracket not required on 2011-14 25-3500 Models:
Move to the Center Mounting Bracket. Select (1) Center Support Bracket-note the two different sizes of mounting holes in the
Bracket. Slide the end of the Center Support Bracket with the larger mounting hole between the factory body mount and the
Center Mounting Bracket. Attach the Support Bracket to the body mount using the included (1) 12mm x 30mm Hex Bolt, (2)
12mm Flat Washers, (1) 12mm Lock Washer and (1) 12mm Hex Nut, (Figures 5 & 6). Do not tighten at this time.
Attach the opposite end of the Support Bracket to the Center Mounting Bracket with (1) 10mm x 30mm Hex Bolt, (2) 10mm
Flat Washers, (1) 10mm Lock Washer and (1) 10mm Hex Nut, (Figures 5 & 6). Do not tighten at this time.
12mm x 30mm Hex Bolt
(2) 12mm Flat Washers
12mm Lock Washer
12mm Hex Nut
Front
Figure 5
5
NOTE: Actual application may vary slightly from illustrations.
Washer and (1) 10mm Flat Washer, (Figures 3 & 4). Do not tighten hardware at this time.
Figure 3
NOTE: Larger hole on the Center Support Bracket mounts to body mount.
10mm x 30mm Hex Bolt
(2) 10mm Flat Washers
10mm Lock Washer
10mm Hex Nut
10mm Nut Plate
10mm x 30mm Hex Bolt
Front
10mm Lock Washer
10mm Flat Washer
Figure 4
Page 3 of 4
Front
IMPORTANT NOTE: 25-3500 Model Front Support Bracket
Installation Pictured.
Bend Support Bracket up by hand to meet the inner hole in
the Front Mounting Bracket
NOTE: Support Bracket not required on 2011-14 25-3500
Models
NOTE: Support Brackets not required on
2011-14 25-3500 Models
Figure 6
Front
Publicidad
