Maintenance Instructions; Cleaning Tool; Cleaning Qcs Coupling; Troubleshooting - RIDGID RE 6 Manual De Instrucciones

Store in a dry, secured area that is out of
WARNING
reach of children and people unfamiliar with the Electric
Tool. The electrical tool is dangerous in the hands of
untrained users.

Maintenance Instructions

WARNING
Remove battery from tool before performing main-
tenance or making any adjustment.

Cleaning Tool

Wipe exterior of the electrical tool clean daily with a clean,
dry cloth.

Cleaning QCS Coupling

Point the QCS opening down and gently shake any debris
out. Visually inspect the QCS opening for any debris.
Cotton swabs can be used to wipe out debris. Do not let
material build up into the retaining ball pockets (Figure 8).
The QCS coupling is lubricated for life at the factory. Do
not add any lubricant to the QCS coupling,

Troubleshooting

SYMPTOM
Tool will not turn ON
when ON/OFF button is
pressed.
The connections
produced are not
complete.
Oil leaks from tool.
Motor runs but tool will
not complete a cycle.
Dies stop during
operation.
Cutting tool stops dur-
ing operation.
See Figure 6 – Tool Status Lights
999-999-463.08_REV. G
POSSIBLE REASONS
Battery is completely discharged or battery has
failed.
Battery not properly inserted into handle of tool.
Used wrong tool/insert for the cable size or mate-
rial.
The tool was not square to the connector.
Tool is in need of repair.
Seal or mechanical problems.
Oil level low.
Oil level low.
Oil Level low.
Cutting edges are dull or broken.
Material not within blade specification.
RE 6/RE 60/RE 600 Electrical Tools
Required Maintenance By RIDGID
Independent Service Center
The Electrical tool must be serviced at set intervals by a
RIDGID Independent Service Center to ensure proper
operation. This will be indicated by a tool status light (See
Figure 6). See Specifications for service interval.

Service And Repair

WARNING
Improper service or repair can make machine
unsafe to operate.
Service and repair on these Electrical Tools must be per-
formed by an RIDGID Independent Crimp Tool Service
Cent er. Use only RIDGID service parts.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions see
Contact Information section in this manual.
Insert fully charged battery/recharge battery.
Check to assure battery is fully inserted.
Install the correct tool/insert.
Make sure that the tool is square to the connector.
See Contact Information for nearest RIDGID Inde -
pendent Service center.
See Contact Information for nearest RIDGID Inde -
pendent Service center.
See Contact Information for nearest RIDGID
Inde pendent Service center.
Replace dull or broken blades with appropriate
replacements.
Change to blade specified for material to be cut.
SOLUTION
9