Wagan Tech 2450 Manual De Usuario página 6

Cordless Spotlight Compressor™ by Wagan Tech®
3. Set the compressor on/off switch to "ON" by changing from
position "O" to "—".
4. Monitor pressure on air pressure gauge.
5. When desired pressure is reached, turn off the compressor.
6. Turn the locking thumb lever to up position and remove stem
connector from valve stem. Also remove the valve stem adapter.
7. Store the compressor hose in its storage compartment.
Note: In the event that the tire is completely flat, raise the vehicle
using a recommended jack before inflating the tire.
B. To Inflate Plastic Inflatable Products
(recreational balls, air mattresses, rubber rafts, etc.):
1. Check manufacturer's specification on item to be inflated for
correct inflation pressure.
2. Open the air hose storage compartment (lifting up the spotlight
lantern) and extend the air hose.
3. Make sure locking thumb lever is at up position. If necessary, use
valve stem adapter. Insert stem connector to valve stem and press
down the locking thumb lever to engage. Make sure connector is
pushed to valve stem as far as possible.
4. Insert other end of valve stem adapter into inflatable air valve stem
as far as practical.
5. Set the compressor on/off switch to "ON" by changing from
position "O" to "—".
6. Monitor pressure on air pressure gauge.
7. When desired pressure is reached, turn off the compressor.
5
www.wagan.com