Broan 455FL Instrucciones De Instalación

MODEL: 455FL
RECESSED MOUNTED STEEL
MEDICINE CABINET
NOTE: This fi xture employs a grounded type receptacle and is
not intended for connection to a two-wire ungrounded source of
supply
INSTALLATION of CABINET
1. Carefully remove all packing material. Place shelves
and hardware bag aside until needed.
2. Determine desired location of cabinet on wall. Mark
wall to show wall opening. Generally, the recommended
height to the center of the cabinet is 64" from the fl oor.
3. CAUTION: Wall studs, plumbing or electrical lines that
interfere must be removed or relocated. Cut wall
opening, being careful not to damage the surrounding
wall surface. Insert framing to support all plaster board
edges. Drill an access hole for the power cable, in the
top of the framing. Fig. 1
4. Remove wire box cover (Fig. 2-A) and run power cable
through wire access hole on top of cabinet (Fig. 2-B).
5. Insert cabinet into wall opening in plumb and centered
position. Use a carpenter's level and shim corners of
cabinet if necessary. Secure to wall studs through the 4
clearance holes inside of cabinet (Fig. 2-C)
Fig. 1
CONNECT ELECTRICAL WIRING
WARNING: Before wiring this product, switch power off at
service entrance and lock service panel to prevent power
from being switched on accidentally.
All electrical connections must be made in accordance with
local code ordinances. If you are unfamiliar with methods of
installing electrical wiring, secure the services of a qualifi ed
electrician.
WHITE
TO
WHITE
For help, call us
toll free!
1-800-637-1453
Register your product online at www.broan.com/register.
Power Cable
Access
Hole
Wall
Opening
GREEN
TO
BLACK
GROUND
TO
WIRE
BLACK
INSTALLATION INSTRUCTIONS
OVERALL SIZE
W H
20 3 / 22 1 / 3
8 4
MIRROR CARE
•
Use only clean warm water and a clean,
soft, lint-free cloth.
•
DO NOT USE cleaners that contain
solutions of ammonia, vinegar, or chlorine.
•
DO NOT USE powdered cleansers or steel
wool.
•
Never spray cleaning agent directly on
mirror, especially on exposed edges and
mirror backing. Apply cleaner to soft cloth
and wipe mirror. Dry mirror thoroughly.
•
Keep mirror dry. A well ventilated bathroom
is important.
B
E
C
A
F
INSTALLATION of SHELVES
1. Remove shelf brackets from hardware bag. Place
brackets into slots on inside wall of cabinet.
2. Place shelf onto shelf brackets, fl at side up.
TO REPLACE FLUORESCENT LIGHTS
1. Purchase two (2) fl uorescent light tubes.
Recommended tubes are F15T8CW.
2. Remove the lens cap (Fig. 2-E) from the top of each
light. Remove the light lenses (Fig. 2-F). Install
light tubes and reassemble lights.
WALL OPENING
D W H D
3 / 14 19 3 1 /
4 2
E
F
D
A99042295G1