®
Mercury
Fan Speed Controller
Easy Guide
Note: This unit has been set to perform in the
"Fire-Up" position from the factory.
VANCOUVER, W ASHINGTON U.S.A.
inStRUCtiOnS – Rev. B
DIAGRAM 1
2
®
Step 1
Plug fan into 120 Volt outlet
on the front of the Mercury
OptiOnal SettingS
"Fire-Up" Feature
The customer can easily enable or disable the "Fire-Up" feature by following
the instructions below. The "Fire-Up" feature will activate your fan at 100%
for 2 seconds and then reduce the speed to match your preferred setting
whenever your fan is activated for the first time or if you experience a power
outage. This improves the start up of your fan and extends the life of your
fan. It is recommended that you enable the 'Fire-Up' feature if you set your
®
Mercury
2 at slow speeds. The default setting from the factory enables the
"Fire-Up" feature.
Step 2
Set your preferred fan setting
2.
on the Mercury
2.
®
®
100%
DIAGRAM 2
®
DIAGRAM 2
Step 3
Plug the Mercury
2 into a 120 Volt wall outlet and fan
®
should be activated at your preferred setting.
installation is now complete.
DIAGRAM 3
The "Fire-up" feature can be activated by the customer by:
• Unplugging the Mercury
®
2 and setting the knob to "100%".
(Diagram 2)
• Then plug the Mercury
®
2 into your 120 volt outlet, turn to 10%
and then turn to 100% within three (3) seconds. (Diagram 3)
• To verify the setting, plug your fan into the Mercury
unplug the Mercury
®
2 and plug back in to see (or hear) the effect
of the "Fire-Up" feature in action.
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
DIAGRAM 3
®
2, then