Publicidad
Idiomas disponibles
Idiomas disponibles
Product Group 19
4 von 10
Warning!
Take any accessories out of the appliance drum.
Note
All repairs should be performed by a trained technician in strict accordance with national, state and local codes.
The stand is suitable only for certain Miele washers/dryers.
Required tools:
T20 Torx Screwdriver, for the back panel of the stand,
The 17 mm open end wrench packed with the appliance for appliance foot, stand foot and stud bolt,
Level for levelling the stand(s).
A
Set-up overview, refer Abb. 1.
A Take the drawer out of the stand, refer Abb. 2.
A
Pull the drawer out to its stop.
A
Lift the drawer up at the front and remove it.
A Take the stand back panel off, refer Abb. 3.
A
Support the back panel while loosening the screws.
A
Remove the screws in the stand back panel (T20 Torx) and take the back panel off.
A
Screw the stand to the washer/dryer, Abb. 4.
Note
Fit the transport struts into the washer.
Remove the detergent drawer.
Drain the water from the filter housing of the washer.
Warning!
To put the washer on its left side, the transport struts have to be fitted.
The surface on which the washer is placed has to be level and soft, such as a carpet.
A Tip the washer on its left side and the dryer on its right side and unscrew the appliance feet.
A
Put two washers each on the set screws.
A
Join the stand to the washer/dryer and fasten together with the bolts.
A Using a 17 mm open end wrench, tighten bolts firmly.
Warning!
When joining, do not wedge the stand and the appliance against each other.
A
Set the washer/dryer/stand combo upright.
A
Screw the back panel to the washer/dryer/stand, refer Abb. 3.
Note
The adhesive strip is facing inward, and the indented drill holes are at the bottom.
A
Set the washer/dryer/stand combo upright on its feet, and level it, refer Abb. 5.
A
Set in, and counterlock, the feet of the washer/dryer/stand.
Note
Remove the washer transport struts.
Insert the washer detergent drawer.
14.12.2006
Conversion and Fitting Instructions
This information should not be duplicated or passed on without Miele approval. All rights reserved.
Mat. no. 06694601
Publicidad
