Kohler STERLING 3190A Serie Guia De Instalacion página 11

Door
Panel
Bottom
Frame
Door Panel
Bottom Frame
Door Panel Bottom
Frame Vinyl Seal
9. Install the Vinyl Seal
Push the vinyl seal into the bottom side of the bottom door frame, as illustrated.
Trim the excess vinyl seal with a sharp knife or scissors.
Close the pivot door.
Verify the pivot door does not rub against the bottom "C" frame.
If the pivot door needs adjustment:
Remove the door panel.
Insert the 1/16" (2 mm) thick nylon washer over the 1/8" (3 mm) thick washer of the bottom pivot
pin.
Reinstall the door.
10. Caulk the Shower Door
CAUTION: Risk of property damage. Apply caulk or silicone sealant around the outside of the frame
only. Applying caulk or silicone sealant to the inside of the door will cause leakage and damage.
Thoroughly clean and dry the shower base ledge and the "C" frame.
IMPORTANT! Refer to the caulk or silicone sealant manufacturer's instructions for proper caulking
techniques.
Apply a 3/16" (5 mm) bead of caulk or silicone sealant around the perimeter of the bottom "C"
frame where the bottom "C" frame meets the shower ledge, as illustrated.
Allow the caulk or silicone sealant to set for 24 hours before using the shower.
Sterling
Door Panel Bottom
Frame Vinyl Seal
Door Panel
Bottom Frame
(Front Side)
Vinyl Leg Toward
Inside of Shower
Caulk here,
outside only.
11
Caulk here,
outside only.
1034048-2-B