3
A.
Optional Extension
Kit Available -
RP72604
C.
5
6
Slide O-ring (1) over cartridge and the
A.
bonnet nut (2). The O-ring,
which acts as a spacer to steady the
sleeve, should rest behind the
bonnet nut. Note: Depending on the
location of valve within the wall and
wall thickness, an optional extension kit
(RP72604) can provide
an additional 1 3/4" of wall thickness.
If your model requires a spacer (3), install
B.
it into sleeve (4). Slide the sleeve over the
cartridge, body and O-ring. Ensure sleeve
is properly positioned over the front of
cartridge.
C.
Secure the escutcheon (5) to the rough
(2) with the 2 screws provided (6). Do not
overtighten escutcheon screws.
2
1
2
4
B.
4
D.
7
8
D.
For T66T036 & T66T038 Traditional series,
remove the top button (7) from the handle
(if already assembled) by pulling straight
up. Look inside bottom of handle to make
sure plastic insert (8) is in place. Make sure
valve is in the full cold position (to the right)
and align lever of lever handle models to the
cold position on the escutcheon and press
handle onto valve stem. Secure handle with
screw provided and press button back into
top of handle.
For all other models which use a set screw
that comes in from the side of the handle
base, look inside the bottom of handle to
make sure the plastic insert (8) is in place.
Make sure valve is in the full cold position
and align lever of lever handle models to
the cold position on the escutcheon and
press handle onto valve stem. Secure
handle with set screw provided.
5
3
90411
Rev. B