Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of ISOFIX System
1. Unfold the Support leg from the base (Fig. 6).
2. After placing the base on the vehicle seat, extend the Support leg to floor (Fig.
7), when the Support leg indicator shows green means it is installed correctly
(Fig. 8).
Make sure the Support leg is fully contact with the vehicle floor pan. Squeeze
the Support leg releasing button, then shorten the Support leg upwards.
3. Press the ISOFIX Pop-up Triggers on two sides and the ISOFIX connectors will
be popup (Fig. 9).
4. Make the ISOFIX connectors face the ISOFIX anchorage system between the
seat and the backrest of the vehicle seat (Fig. 10).
5. Click the child seat ISOFIX connectors into the ISOFIX anchorage system. When
clicking in (Fig. 11), the indicators informing you about the correct installation,
should be green (Fig. 11.1) and your child restraint's backrest is aligned parallel
(Fig. 11) with the backrest of the vehicle seat.
Make sure that both ISOFIX connectors are securely attached to their ISOFIX
anchor points. The colors of the indicators on the both ISOFIX connectors
should be completely green (Fig. 11.1).
Check to make sure the base is securely installed by pulling on the both ISOFIX
connectors.
6. The completely assembled base is shown as (Fig. 12). The ISOFIX connectors
must be attached and locked onto the ISOFIX anchor points (Fig. 12.1).
The support leg must be installed correctly with green indicator (Fig. 12.2).
7. Please refer to rearward facing and forward facing in section to use the child
restraint.
8. To remove the child restraint, turn the ISOFIX connectors switches off and the
indicators will be red, meanwhile you will hear the "click"- sound, the ISOFIX
connectors will be bounce off and then can be removed from the anchorage
system of vehicle seat (Fig. 13). The ISOFIX is folded completely.
23
Publicidad
