wattstopper RS-150BA-N Guia De Inicio Rapido

Please read all instructions before installing
SPECIFICATIONS
Voltage ............................................................... 120VAC, 60Hz
Load (Single Pole)
Incandescent or fluorescent light...................... 0-600 Watt
Fan motor .................................................................. 1/6 hp
Time Delay.............................................................. 30 minutes
Environment ..................................................... Indoor use only
Operating Temperature ............... 32° to 131°F (0° to 55°C)
Humidity ...................................... 95% RH, non-condensing
Tools Needed
Insulated Screwdriver
Wire Strippers
DESCRIPTION AND OPERATION
The RS-150BA-N Vacancy Sensor is designed to replace a standard light or fan
switch.
Like a standard switch, you press the ON/OFF button to turn the light or fan
(controlled load) ON and OFF. Unlike a standard switch, the RS-150BA-N
automatically turns OFF the controlled load after the coverage area has
been vacant for 30 minutes. If motion is detected within 30 seconds after it
automatically turns OFF, the RS-150BA-N automatically turns the load back ON.
Nightlight
While the controlled load is OFF, the nightlight built into the RS-150BA-N is on.
When the load is ON, the nightlight is OFF.
Coverage Area
The RS-150BA-N has a maximum coverage range of 180 degrees and a coverage
area of 600 square feet (56 square meters). The sensor must have a clear and
unobstructed view of the coverage area. Objects blocking the sensor's lens may
prevent detection thereby causing the light to turn off even though someone is in
the area.
Windows, glass doors, and other transparent
barriers will obstruct the sensor's
view and prevent detection.
PIR Wall Switch Vacancy Sensor
Call 800.879.8585 for Technical Support
RS-150BA-N
with Nightlight
Santa Clara, CA 95050
Fig 1: Sensor Coverage Area
25'
(7.6m)
12'
(3.7m)