Important safeguards
When using electrical products, especially when children are present, basic safety precautions should always be followed, inclu-
ding the following:
Please read this manual carefully before product installation and use.
DANGER- For reducing the possibility of electric shock
1. Do not place or store the remote control at where it can fall or be pulled into the bathtub, sink or tank.
2. Do not place the remote control into the water or other liquid.
3. Do not splash this product with water.
WARNING- To reduce the risk of burn, electrocution, fire or injury.
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
3. Use this product only for its intended use as described in this manual.
4. Do not operate the product with damaged cord or plug, or after the product malfunctions, or has been damaged in any way,
or dropped into water. Return the product to the nearest authorized service center for examination, repair, or adjustment.
5. Keep the power cord away from heated surface.
6. Never use this product while sleeping or drowsy.
7. Never drop or insert any object into any opening of product or hose.
8. Do not use this product outdoors.
9. Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the equipment.
This can influence other equipment (e.g. blinking of a lamp).
If the MAINS-IMPEDANCE Zmax < 0.3 OHM, such disturbances are not expected.
(In case of need, you may contact your local supply authority for further information).
10. Save these instructions.
11. Rain water, demineralized water, sea water or grey water are not suitable to operate this equipment. The Multiclean shower
toilet may only be operated with normal drinking water.
220V-240V~,
50/60Hz
1300W
Grounding instructions
1. The plug must be plugged into an outlet that is properly installed
grounded.
2. In the event of an electrical short circuit, grounding reduces the risk of
electric shock.
3. The electrical outlet, which must be a 220-240V~, 50/60Hz, and at
least a 15Amp grounded outlet, should be located on the wall within
reach of the unit's power cord.
4. A Ground Fault Interrupter residual current device (RCD) should be
installed on the circuit supplying power to the unit.
DANGER- Improper use of the grounding plug can result in a risk
of electric shock.
If repair or replacement the cord or plug is necessary, do not connect the
grounding wire to either flat blade terminal.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if in doubt as to whether
the product is properly grounded.
If it is necessary to use an extension cord, make sure the extension is
grounded.
2