Publicidad
Idiomas disponibles
Idiomas disponibles
www.digisportinternational.com
INSTRUCTION MANUAL
TIMER DT3L
FEATURES:
Tri-display count down
Maximum count down / up 19hr 59min
59sec
1/100 second count up display
12 / 24 hours time format
Foldaway stand
Magnetic attachment
SPECIFICATION:
Maximum count
19 hours 59 minutes
down / up range
59 seconds
Count down display
1 second
resolution
Count up display
1/100 second
resolution
42 (W) 45 (H) mm
Display size
6 (W) 12 (H) mm
Digit size
1.5 volt, size LR44 or
equivalent 2 pieces
Battery
(included)
70 (W) 90 (H) 14
Product size
(D) mm
INSTALLATION:
1. Slide down battery cover
2. Install batteries with correct polarity
positioning
3. Put back battery cover
4. Peel off display protective sheet
5. Press and hold [CLOCK/TIMER]
until display flashing
6. Press [12 / 24] button on the back
to select 12 or 24 hours time format
7. Press [HR], [MIN] and [SEC] to set
the correct time*
8. Press [CLOCK/TIMER] to finish
clock setting
COUNT DOWN TIMER:
1. Press [CLOCK/TIMER] to select
timer mode
2. Press and hold [T1] until "TIMER
1" icon flashing
3. Press [HR], [MIN] and [SEC] to
set the desired count down time*
4. Press [T1] to finish TIMER 1
setting
5. Repeat above procedures 2 – 4
to set TIMER 2 and 3
6. Press [START/STOP/MEMORY]
to start all timers' count down
simultaneously
7. Press the button again to pause
8. Press the button once more to
resume count down
9. The timer will sound when each
setting's display value becomes
0:00 00 and will be counting up to
show the elapsed time
10. Press
[START/STOP/MEMORY] will stop
TIMER 1, press the button again
will stop TIMER 2 and press the
button once more will stop TIMER 3
11. Press [CLEAR] to clear all
values
12. Press
[START/STOP/MEMORY]
display
the
memorized
values
13. To
operate
each
individually, press T1, T2 or T3
respectively to start or stop the
timer, or recall the memorized
preset values after pressing the
[CLEAR] button.
COUNT UP TIMER:
1. Press [CLOCK/TIMER] to select
clock mode
2. Press [CLEAR] to clear display's
values
3. Press [START/STOP/MEMORY]
to start count up
4. Press the button again to pause
5. Press the button to resume count
up
* During setting the values, press
and hold the [HR], [MIN] or [SEC]
button will increase the values
automatically.
CARE OF YOUR STOPWATCH:
SHOCK
-
Be
careful
not to
drop
stopwatch or hit it against hard
subjects as it may cause a mechanical
damage.
TEMPERATURE
- Do not leave your stopwatch under
direct
sunlight
temperatures for a long time, or the
display may become black. Do not
leave your stopwatch in very low
temperature as this may cause a slight
time loss or gain and the change of
digits become slow. In both cases the
above conditions will be corrected
when the stopwatch returns to normal
temperature.
WATER-RESISTANCE
- The stopwatch is designed to
withstand accidental contact of water
such as splashes or raindrops, but is
not for use under water.
STATIC ELECTRICITY
- The integrated circuit
stopwatch can be affected by static
electricity. IF the static is very strong a
will
permanent damage can be incurred.
preset
Be careful of the screen of the TV set
and the wearing of clothing made of
timer
synthetic material in dry weather, in
such cases a very strong static
electricity can be generated.
MAGNETISM
- Not affected
CHEMICALS
- Do not expose your stopwatch to
solvents such as gasoline and alcohol,
spray of cosmetics, cleaners, paints
etc as they may cause damage to the
stopwatch.
BATTERY CHANGE
- When the display becomes dim of
faded out, battery replacement is
necessary.
1. Unscrew and remove back cover.
2. Replace with 1 pc fresh V13GA
1.5V
(Dia.
equivalent.
3. Don't use any metal tweezers to
handle the battery or it may cause a
your
short-circuit.
4. Re-screw the back cover, making
sure that the gasket is in the correct
position.
THE WARRANTY DOES
NOT COVER THE
BATTERY.
Use a battery of quality.
or
in
very
high
in your
11.6x5.4mm)
or
Publicidad
