Williams Sound R1–173 Instrucciones De Uso Y Cuidado

R1–173 & R1-174 Personal Receiver (AA)
Instructions For Use & Care
O I
PERATING NSTRUCTIONS
1. Install two (2) AA batteries. If you're using rechargeable
batteries, they must be charged before using.
2. Plug the earphone into the "EAR" jack on the control
panel.
3. Use the earphone in your best ear.
Ear
EAR
Jack
4. Turn the receiver on by rotating the control knob. The
receiver's ON indicator should light.
5. Adjust the volume for your comfort.
6. To turn the receiver off, rotate the control knob until it
clicks off. The receiver's ON indicator should go dark.
Note: To maximize battery life, turn the receiver off
when it's not in use.
Note On The Receiver Antenna:
The earphone cord is the receiving antenna. Do not bunch
up the cord or wrap it around the receiver. For best recep-
tion, the cord should hang as straight as possible.
E C
ARPAD LEANING
Do not immerse the earphone in water or other cleaning
agent. Foam pads may be removed and washed with a
mild laundry soap solution, rinsed thoroughly, and air-
dried. Foam pads may also be replaced with new pads.
B I
ATTERY NSTRUCTIONS
This receiver can use disposable alkaline AA batteries
(BAT 001) or a Williams Sound rechargeable battery
(BAT 026). BAT 026 batteries will last about 20 hours
per charge when used with Williams Sound Receivers.
BAT 001 batteries will last approx. 30 hours when used
with Williams Sound Receivers. Batteries from other
suppliers may provide different operating life. Do not
mix batteries and chargers from different manufacturers.
DO NOT TRY TO RECHARGE NON-RECHARGE-
ABLE BATTERIES.
E B L
XPECTED ATTERY
Alkaline batteries (BAT 001):
Rechargeable NiMH batteries (BAT 026):
Charging Time:
On/Off
Volume
Indicator
1
Volume
Control
IFE
30 hrs
20 hrs per charge
12-14 hrs
I R
NSTALLING AND EPLACING
1. Open the battery compartment by lifting the tab on the
bottom of the receiver with a coin or finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. To install new batteries, press them into place over the
fabric strip. Be sure to observe proper polarity (+/–).
Rear of
Receiver
Battery
Compartment
Note Proper
Polarity
4. Close the lid.
5. When the sound becomes weak or distorted, replace or
recharge batteries. If recharging, use the Williams Sound
CHG 200 or CHG 1600 Battery Charger.
W N
ARRANTY OTICE
Your personal receiver is engineered and designed to
provide you with many years of reliable service.
Williams Sound warrants it against defects in materials
and workmanship for FIVE (5) years EXCEPT FOR ear-
phones, headphones, batteries, chargers, cables, antennas,
carry cases, and all other accessory products. Accessory
products carry a 90 day warranty.
If the receiver fails within the warranty period, Williams
Sound will determine whether to repair or replace it. This
warranty does not apply to physical damage, receivers
that have been abused or mis-used, or modified.
Williams Sound Products are NOT designed for use in
extreme temperature, humidity, or chemical environ-
ments. The introduction of chemicals such as chlorine,
salt water, or human sweat into the product will cause
damage to the circuitry. Damage due to these causes IS
NOT covered under the product warranty.
Williams Sound
©2004, Williams Sound Corp.
English
Inglés
B
ATTERIES
– +
+ –
Helping People Hear
www.tour-guide-systems.com
FRM 424C
Pry
Slot
®