Operation; Getting Started; Setting Sensitivity In Test Mode; Selecting Function - Home Decorators Collection HB7251MA-292 Guía De Uso Y Mantenimiento

Operation

GETTING STARTED

 Slide the "TIMER" switch to "TEST".

Restore power at the circuit breaker and turn on your wall switch (if applicable).

The light will turn on and remain on for approximately 45 seconds. Then the light will flash 3
times and then turn off. (If the "TIMER" switch is set to "6 HOUR" and it is night, the light will
stay on continuously until you switch to "TEST".)

It is necessary to first switch to TEST mode to allow you to easily set the motion sensor
sensitivity.

In TEST mode, the motion sensor will turn on the light when it senses movement. Four to five
seconds after movement has stopped, the light will turn off.

SETTING SENSITIVITY IN TEST MODE

NOTE: Sensitivity directly correlates to the
sensor's detection range.
 In TEST mode, slide the "SENSITIVITY" switch to a desired level: "L" for low, "M" for medium, or
"H" for high. From a distance, walk through the coverage area. When the light turns on, note
your distance from the fixture. Try different approaches toward the fixture from various angles.
Especially, try pathways where you expect high traffic, such as walkways and driveways.
 If necessary, select a different "SENSITIVITY" switch position to increase or decrease
sensitivity/range. Repeat the steps above. Continue to adjust the sensitivity until optimum
results are attained.

SELECTING FUNCTION

 After setting the sensitivity, select the function by sliding to "TIMER" switch to one of the
following positions:
"TIMER"
Switch Position
4
10
6 HOUR
Function
At dusk, the motion sensor will activate (Motion Sensing Mode).
Any movement within the coverage area, will cause the light to
Motion turn on. After movement has stopped, the light will remain on for
the preset time limit (4 or 10 minutes). At the time limit, the light
Sensor
will turn off. The motion sensor will remain active throughout the
night. At dawn, the motion sensor will deactivate.
At dusk, the light will turn on and remain on for 5 to 6 hours. At
this time, the light will turn off and the motion sensor will activate
(Motion Sensing Mode). Any movement within the coverage
Six Hour
area, will cause the light to turn on and remain on for 10 minutes.
Timer
At 10 minutes, the light will turn off. The motion sensor will
remain active throughout the night. At dawn, the motion sensor
will deactivate.
Description
8