Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
6
Important
Only use Philips s-bag™ double-layer paper dustbags, Philips Sydney+ double-layer paper
dustbags (HR 6999) or the cotton dustbag if provided.
Never use the vacuum cleaner to suck up water or any other liquid. Never suck up ashes
until they are cold.
When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become
clogged, causing the passage of air through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the
dustbag is not full at all.
Never use the appliance without the Motor Protection Filter.This could damage the motor
and shorten the life of the appliance.
Connecting accessories
Hose
1
To connect the hose to the appliance, push it into the appliance and turn it clockwise.(fig.1)
2
To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the
appliance.
Tube
Conical coupling (specific types only)
To connect the tubes to the handgrip, insert the narrow section into the wider section while
turning it.(fig.2)
Use the same method to connect the accessories to the tube.
To disconnect, turn the tube or the accessories anticlockwise and pull.
Button coupling (specific types only)
Connect the tube to the handgrip ("click").(fig.3)
Use the same method to connect the accessories to the tube.
To disconnect the tube from the handgrip, push the lock button and pull the tube out of the
handgrip.The accessories are disconnected in the same way.
Telescopic tube (specific types only)
1
Connect the tube to the handgrip ("click").
2
Adjust the tube to the length you find most comfortable during vacuum cleaning.(fig.4)
Convertible nozzle (specific types only)
The convertible nozzle can be used on either carpets or hard floors.
1
Connect the convertible nozzle to the telescopic tube ("click").
2
Push the rocker switch on top of the convertible nozzle with your foot to make the brush
strip for cleaning hard floors come out of the nozzle housing.(fig.5)
3
Push the rocker switch again to make brush strip disappear into the convertible nozzle
housing again.(fig.6)
Reach & Clean nozzle (specific types only)
The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be
turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach
places in an easy way.When the nozzle is positioned lengthwise, the suction power is
concentrated at the front side of the nozzle.(fig.7)
Publicidad
