Quarkpro QF-1500 Manual De Usuario página 7

REMOVE PACKAGE AND CHECK
1.- Open carton to check whether all necessary spare parts include accord the specifica-
tion list. Please contact distributor if there are something missed.
2.- Check the appearance of machine and power line to see whether they have some
obvious damage. Please contact distributor once you find something and stop to use fog
machine.
INSTALLATION
1.- Take away all pack material especially the spray mouth.
2.- Set in the horizontal direction and open the cover of liquid can.
3.- Add high quality fog liquid in the machine and screw the cover of liquid can. Bad
quality fog liquid will damage fog machine.
4.- Plug the plug of remote console in the socket of the back of machine.
OPERATION
1.- Connect the power line to the power socket with earth line. Turn the switch
at " On " and the machine heat. The red LED of line console will light once the
machine finish heat.
2.- Press red key, the machine will spray fog (Press it as long as you need).
3.- The red LED of remote console light or not means the machine can spray fog
or heat itself.
4.- Can set the machine at a high place (with hanger) or on the ground. Do not spray fog
to people directly and the lean angle should less than 15º.
5.- Often check whether there has enough fog liquid in machine. The operation will make
big damage to the machine if there has no fog liquid.
6.- If the fog is small, plum has noise or there has no fog, please power off and check fog
liquid, fuse, the connector of remote console and power plug. If the problem could not
be solved after check these parts, please stop check and send it back to distributor
for repair.
SPECIFICATIONS
Power: 1500W
Voltage: AC110V 230V 50Hz
Heat-up Time: 8minutes
Weight: 8,5KG
Size: 49*33*27,5(cm)
Smog oil capacity: 2,5L
Spraying Distance: 10M
Output: 20000cu.ff/min
Remote control & DMX512 Control
Electronic temperature control
Ratio controller
5