Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (continued)
5.
From underneath the sink, screw the bottom gasket (5.1) and mounting
nut (5.2) onto the drain assembly (C) by twisting until secure against the
bottom of the sink.
IMPORTANT: Remember to reconnect the drain body to the P-Trap drain
assembly (not included) before testing the faucet.
6.
Attach the end of each integrated supply line (6.1) from the faucet body (A) to
the hot and cold water supply valves (6.2) under the sink, after making sure
the supply valves (6.2) are clear of any debris. Thread the nut on the end of
the integrated supply line (6.1) onto the outlet of the water supply valve (6.2)
and tighten with a wrench. Do not overtighten. NOTE: The hot side inlet tube
is indicated by a label.
NOTE: Do not use PTFE pipe tape, plumber's putty, pipe dope, or any other
type of sealing compound on the water inlets or threads. Additional compound
is not necessary. A watertight seal between the supply valve and the nut on the
integrated supply line is achieved by compression.
7.
After installation is complete, turn on the water supply and adjust the handle
(8.1) on the faucet body (A) to the warm position where it mixes both hot and
cold water. Allow the water to run for at least one minute to flush away any
debris that could cause damage to the internal parts. While the water is running,
check for leaks. If leaks occur, gently tighten the nut on the connection that is
leaking. Fill the sink with water to check the drain for leaks. If water is leaking
from the drain, tighten the nut on the drain assembly (C). Turn off the water
and empty the sink.
5
5
C
5.1
5.2
6
6.1
6.2
7
7.1
A
Publicidad
