Spectroline uVision Serie Manual De Instrucciones página 2

UV emitted from this product. Avoid eye and skin exposure to unshielded products.
IMPORTANT SAFETY INSTRUCTIONS (Read all instructions)
Do not operate the uVision™ Series UV-A/White Light LED NDT Inspection Lamp
•
(UV-365SBLC/UV-365MSBLC) if the lamp has been damaged.
Do not look directly into the light. ALWAYS wear the UV-absorbing protective glasses
•
provided when operating the lamp. Use in low-light conditions to achieve the best inspection
results. The darker the room, the greater the fluorescent contrast.
• The uVision™ is not approved for use in hazardous atmospheres. Do not attempt to use it in
areas requiring explosion-proof lighting.
• Never use this equipment in any manner not specified in these instructions because your
protection may be impaired.
• NEVER aim the lamp in the direction of another human being. It is meant for professional
fluorescent inspections ONLY!
• DO NOT attempt to modify the lens assembly or light output. Doing so may alter the
performance and intensity of the uVision™.
OPERATION
• The uVision™ series UV-A inspection lamps are equipped with a heavy-duty power cord.
• The lamp is shipped with the correct cord installed for the country of destination.
• Connect the plug to a power source that complies with the electrical requirements specified
on the label.
• The lamp has a three-position rocker power switch (II – UV; O – off; I – white light) on the
handle.
• The UV-365SBLC and UV-365MSBLC have White Light Intensity Adjustment Controls
located on the back plate of the lamp. The Battery Indicator is also located on the back plate
of the lamp. The Battery Indicator light will be Orange when the battery is charged and the
lamp is operating within RRES compliance. When the battery is nearly depleted, the light will
flash between Red and Orange. Detailed instructions for recharging the battery are located
on Page 4.
• The UV-365SBLC and UV-365MSBLC are designed to automatically shut off if the unit
operates outside of RRES compliance standards. To turn the unit back ON from a shut off
event, turn the lamp OFF and then ON using the three-position rocker switch.
• WARNING: Be sure to use genuine uVision™ replacement parts. Using another
manufacturer's replacement parts could affect product performance and will void the
warranty.
Rocker Switch
CHANGING THE LAMP POWER
The appropriate cord for the country of destination will be installed on the lamp when it is ordered.
The power cord is integrated into the lower portion of the lamp handle, forming a cord/handle
assembly. A set of detailed instructions for changing the lamp cord come with the replacement
parts. Contact Customer Service for more details. Call toll-free 1-866-230-7305.
WARNING
FOR PROFESSIONAL EXAMINATION USE ONLY
White Light
Intensity
Adjustment
SUPPLY
2
Battery
Indicator