FeinTech FeinControl SDF00400 Guia De Inicio Rapido página 2

FeinControl SDF00400
Universal big button remote control
small power button
red LED indicator
large power button*
number buttons
*for learning mode press large power
button and channel down key simulta-
neously
AV / external input button
OK button
channel up button
volume down / up buttons
channel down button*
lamp button to activate illumination
special buttons 1 & 2
Hint: To assign special functions of the original remote control (such
as mute, menu or teletext), you can use the two special buttons.
Functionality: The FeinControl can learn the most important keyboard commands of an existing infrared remote
control and then send them like the original. The few and large keys make it easy to operate - ideal for seniors. The
switchable lighting simplifies operation in the dark.
If necessary, the FeinControl can copy individual commands from a third remote control. For example, you can copy
the program selection buttons from TV's remote control, but the volume control from the audio amplifier's. You can
assign the buttons according to your own preferences.
Preparation: Insert batteries into the FeinControl and the desired source remote control. Place the remote controls
at a distance of approx. 4 cm from each other on a table so that the infrared transmitters are facing each other:
Learning mode: Press the large power button and keep it pressed. Then briefly press the "Channel down" button
at the same time. The red LED now flashes permanently, the FeinControl is in learning mode.
To learn, first press the desired target button on the FeinControl. The red LED then lights up permanently. Now press
the button on the source remote control. When the command has been accepted, the LED flashes again. You can
now continue with the next button.
Note: If you do not press any key for 15 seconds, the learning mode switches off. Previously saved commands are
retained. You can restart the learning mode at any time. You can change the saved key assignments as you wish. All
settings are retained even after the battery has been changed.
The learning mode can be ended by holding down the large power button and then pressing the "Channel down"
∨
button . The LED goes out and you are in the operating mode. Now control your device comfortably with the
FeinControl. The red LED lights up briefly each time the button is pressed.
Illumination: For better operation in the dark, the FeinControl has a key illumination. Press the lamp symbol to
switch it on. The light switches off automatically 7 seconds after the last key press.
required battery type: 2 x AAA (not included)
FeinTech is a registered trademark of Spreewald Kommunikationstechnik GmbH
Radensdorfer Hauptstr. 45 a - 15907 Lübben (Spreewald) - Germany
english
∨