Putting Into Operation; Switching On; Selecting The Temperature Setting; Automatic Switch-Back - Bosch+Sohn bosotherm 2200 Instrucciones Para El Uso

4.2 Putting into operation

Spread out the heated underblanket flat onto your mattress starting at the foot end.
Then put on your bedsheet in the usual manner so that the heated underblanket is between your mattress
and the bedsheet.
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the switch to the heated underblanket by plugging in the
connector.
• Then plug in the supply plug into the mains outlet.

4.3 Switching on

Set the ON/OFF slider (4) to the ON (I) position to switch on the electric underblanket (see Fig. switch). The
temperature settings will then light up.

4.4 Selecting the temperature setting

To increase the temperature, press the
After switching on the temperature setting is illuminated.
Setting 0: OFF
Setting 1: minimum heat
Setting 2-3: Individual heat
Setting 4: maximum heat
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overhe-
ating of the user.
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the switch, first.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.

4.5 Automatic switch-back

NOTE:
This electric underblanket features an automatic switch-back for safety purposes. Temperature settings
4 and 3 are automatically switched to temperature setting 2 after 3 hours.

4.6 Automatic switch-off

This electric underblanket is equipped with an automatic switch-off. This turns off the heat supply 12 hours
after the electric underblanket is first switched on. This is indicated by a flashing temperature setting. In order
to reactivate the electric underblanket, the sliding switch (4) must initially be set to off ("0" position). After about
5 seconds it is possible to switch it on again. If the electric underblanket will not be used after timed switch-off,
it should be switched off (sliding switch to position "0") and the mains plug removed from the mains socket.
button (6). To decrease the temperature, press the
13
button (7).