Garmin NMEA 2000 Instrucciones De Instalación página 4

Adapter cable
Wiring
connections
NMEA 2000 Transducer Adapter Kit installation Layout
Mounting the NMEA 2000 Transducer Adapter Kit
After you have determined a suitable location to install the NMEA 2000 Transducer Adapter,
use the included mounting bracket to mount it to the bulkhead or other suitable structure.
1. Using the mounting bracket as a template, mark the four pilot-hole locations.
2. Using a / in (2.5 mm) drill bit, drill the four pilot holes.
3
32
3. Place the adapter in the bracket and secure the mounting bracket to the mounting surface
using the included 10 mm M3 screws.
Wiring the NMEA 2000 Transducer Adapter Kit to the
installed Transducer
Use the included adapter cable to wire the NMEA 2000 Transducer Adapter Kit to the installed
transducer.
To wire the adapter cable to the installed transducer:
1. Disconnect the installed transducer from the installed display device.
2. Cut the three wires from the installed transducer to the same length. Do not strip the wire
insulation. If the installed transducer has more than the three wires indicated in the wiring
assignment table, cut and tape the additional wires.
3. Use the included water-resistant connectors to connect the wires from the installed
transducer to the wires on the included adapter cable, according to the wiring assignment
table. (See page
NoTE: Some installed transducers may have a purple wire instead of a blue wire. If your
transducer has a purple wire, connect it to the blue wire on the adapter cable.

Cable tie-down
5)
Adapter Cable
Black
Blue
Green
Wiring Assignment Table
NMEA 2000
drop cable
NMEA 2000
transducer adapter
Mounting
bracket
point
Installed
transducer
installed Transducer
Black
Blue or purple
Bare wire
NMEA 2000 Transducer Adapter Kit Installation Instructions
To the
existing
NMEA 2000
network