Operation Instructions; Timer Function - Black and Decker BDT20WTB Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SET UP & USE

OPERATION INSTRUCTIONS

NOTE: Unit may shut off automatically during 24 hour period if collection bucket
is full (see below). If continuous drainage mode is utilized, and drain hose
is connected, the unit will operate continuously (see page 12).
1. Press the POWER button once to turn the unit on. Press POWER button again
when you're ready to turn it off.
2. Press the
or
humidity in the room. Each press will change the room humidity by 5%. The
room humidity is selectable from 35-80% or continuous. The unit will cycle on
and off to maintain the humidity level chosen on the digital display. After few
seconds, it will display the ambient humidity. When the ambient humidity is
lower than the set humidity, the compressor will stop running, and after few
minutes the fan will stop running.
3. If you want the dehumidifier to operate continuously regardless of the room
humidity,
press button until you see "CO" on the display. This will enable
continuous operation and the
4. Press the FAN SPEED button to select between High and Low Speeds. If HIGH
speed is selected the

TIMER FUNCTION

To program the unit to automatically turn ON, press the TIMER button when
the unit is OFF. Press the
up to 10 hours. After 10 hours, each press of the
hour increments up to 24 hours. Once the desired time is reached, the unit will
automatically turn ON.
To program the unit to automatically turn OFF, press the TIMER button when
the unit is ON. Each press of the
in 30 minute increments up to 10 hours. After 10 hours, each press of the
buttons will increase or decrease the timer in 1 hour increments up to 24 hours.
Once the desired time is over, the unit will automatically power OFF.
FULL WATER COLLECTION BUCKET
When the water collection bucket is full, the unit will shut off automatically, make
a beeping noise and the BUCKET FULL indicator will light. The dehumidifier will
not run again until the bucket is emptied and properly placed back inside the
unit.
buttons under the display to select the desired relative
indicator will light up on the control panel.
indicator will light up.
or
to increase the timer in 30 minute increments
or
will increase the timer in 1
buttons will change the timer setting
or
Page 9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bdt30wtbBdt40wtbBdt50wtbBdt50pwtb

Tabla de contenido