Safety Instructions - RCA RTS796B Manual De Usuario

SAFETY INSTRUCTIONS

WARNINg: THE APPARATUS SHALL NOT BE
EXPOSED TO DRIPPING OR SPLASHING AND
THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH
AS VASES, SHALL BE PLACED ON APPARATUS.
WARNINg: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR
MOISTURE.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR
EN
PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
ON PlACEmENT
• Do not use the unit in places that are extremely
hot, cold, dusty, or humid.
• The ventilation should not be impeded by covering
the ventilation openings with items such as
newspaper, table-cloths, curtains, etc.
ON SAFETY
• When connecting or disconnecting the AC power
cord, grip the plug and not the cord itself. Pulling
the cord may damage it and create a hazard.
• When you are not going to use the unit for a long
period of time, disconnect the AC power cord.
• No naked flame sources such as lighted candles
should be placed on the AC power cord and the
unit.
• Leave a minimum of 10 cm around the apparatus
for ventilation.
• Attention should be drawn to the environmental
aspects of battery disposal.
• Use of apparatus in moderate climates.
ON CONdENSATION
• When left in a heated room where it is warm and
damp, water droplets or condensation may form
inside the unit. When there is condensation inside
the unit, the unit may not function normally. Let
the unit stand for 1 to 2 hours before turning the
power on, or gradually heat the room and let the
unit dry before use.
RATINg PlATE lOCATION
• The rating plate is located at the rear of unit.
WARNINg:
• Should any trouble occur, disconnect
the AC power cord and refer servicing to a
qualified technician.
• Mains plug is used as the disconnect device, it
shall remain readily operable and should not be
obstructed during intended use. To be completely
disconnected the apparatus from supply mains, the
mains plug of the apparatus shall be disconnected
from the mains socket outlet completely.
FCC INFORmATION
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
2
RTS796B 3L IB.indd 2
All manuals and user guides at all-guides.com
CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH THE
SAME OR EQUIVALENT TYPE.
CAUTION: TO REDUCE THE RISK OF FIRE, DO NOT
PLACE ANY HEATING OR COOKING APPARATUS
BENEATH THIS UNIT.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT OF POWER
OUTLET, THEN FULLY INSERT.
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
• Connect the equipment into an outlet on a circuit
• Consult the dealer or an experienced radio/TV
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
FOR CUSTOmERS IN CANAdA
This apparatus complies with the Class B limits for
radio noise emission set out in radio interference
regulations.
CAN ICES-3 (B) / NMB-3 (B)
ImPORTANT SAFETY
INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6.
7.
8.
and receiver.
different from that to which the receiver is
connected.
technician for help.
Clean only with a dry cloth.
Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
Do not install near any heat sources such
2/18/2014 10:07:36