Philips HI 901 Manual Del Usario página 6

the hissing sound again. Wait again until the
sound stops. Proceed in the same manner until
the cap is unscrewed.
- Wait for a few minutes. Then slowly pour
water into the filling opening (C) (fig. 2).
- Close the steam tank by turning the screw cap
manually (clockwise) until tight (fig. 3).
Steam-ironing
• As indicated on the temperature dial (G) and
the table, steam-ironing is only possible at
higher ironing temperatures, so set the dial to
2 or 3.
6
- Insert the mains plug into a wall socket.
- Set switch "On/Off" (B) to position |. The pilot
light in the switch will come on (fig. 6).
- Select the required ironing temperature with the
temperature dial (G) (fig. 7).
- After a few minutes, pilot light (F) will go out.
This indicates that the soleplate has reached
the set temperature.
- Approximately 8 minutes after switching on the
steam tank is heated up and steam is ready.
Then you can start steam ironing.
- While steam-ironing keep the steam activator
(E) pressed-in (fig. 8).
• During steam-ironing
pilot light (F) will come
on from time to time.
When this happens,
the iron being heated-
up to the required
temperature. You can
continue ironing.
Steaming in a vertical position
Hanging curtains and
clothing (jackets,
woman's suits, coats) can
be steamed by holding
the iron in a vertical
position (fig. 9).
7
8
9
Dry-ironing
• For ironing without steam, do not press-in the
steam activator (E).
When finished ironing
- Switch off (fig. 10).
- Remove the mains plug
from the wall socket.
- Place the iron on the
stand and let it cool
down.
• It is not necessary to
pour the remainder of
the water out of the
steam tank.
Cleaning
- Before cleaning remove the mains plug from
the wall socket and allow the iron to cool down
sufficiently.
- The appliance can be cleaned with a damp
cloth.
Storage
- For transport there are
handgrips on either
side of the steam tank
(fig. 11).
Regularly check if the
mains cord and the
supply hose are still in a
good and safe condition.
6
10
11