Publicidad
Idiomas disponibles
Idiomas disponibles
Fan Replacement Information
To replace the fan, please make sure the fan connector
z
is compatible with the 2-PIN or 3-PIN connections on
the device.
Note:
1. ICY DOCK reserves the right to change unrelated technical specifications and is subject to change without prior notice.
2. ICY DOCK will not be liable for any software, hardware, or data stored within or interfacing with ICY DOCK products which results
in damage or malfunction. ICY DOCK will only be responsible for repairs and services of ICY DOCK products.
3. Due to different drive specifications for the drive access signal, some drives may not support the access LED. If the LED does
not function, but the user can read and write to the drive, it falls under this category. If the LED does not function, and the drive
cannot be read or written to, please contact us for troubleshooting.
4. To utilize the hot swap function, the host must also support hot swap. To check if your host supports hot swap, please refer
to the motherboard or controller card specifications and user manual.
5. For further questions or concerns about ICY DOCK products, please visit us at www.icydock.com
6. This product is not compatible with 3.5" SATA hard drives less than 25.4mm thickness.
7. To replace a fan, a 80 x 80 x 25mm fan will be compatible for this device.
2 PIN
Fan cable routing
English
3 PIN
Publicidad
