Publicidad
Step 2
Separate the EXTENSION SLIDES (M) from the
å
EXTENSION RAILS (L) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (L) to the FRONT/REAR
å
MOLDINGS (J2 and K2). Use eight GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
L
Open end
Page 6
M
Push the black lever in and pull the SLIDE from the RAIL.
This hole must be here in the
center of each FRONT/REAR
MOLDING.
K2
L
K2
L
J2
420374
L
Open end
L
J2
www.sauder.com/services
Publicidad
