Frontal Panel Description; Default Settings - CPA EL 10 pH-rx Manual De Regulatión

ENGLISH

FRONTAL PANEL DESCRIPTION

GENERAL FUNCTIONS OF THE PUMP :
- 4 LANGUAGES MENU: ITALIAN, ENGLISH, FRENCH, SPANISH
- pH or mV (Rx) CONTROL CHOICE
- 3 POSSIBLE TYPES OF FUNCTIONING: MANUAL, ON/OFF, PROPORTIONAL
- ALARM TIME OF OVERDOSAGE
- START UP DELAY
- DEFAULT PARAMETER RESTORING
- WATER FLOW CONTROL
- LEVEL CONTROL
- OVER RANGE AND UNDER RANGE OF THE MEASURE
- STOP DOSING ( STAND_BY )
- REAL TIME FLOW RATE %

DEFAULT SETTINGS

type pH:
 FUNCTIONING: Prop
 SETPOINT: 7.2 pH
 DIRECTION DOSING: Acid
 INJECTION FREQUENCY:100%(150 imp/min)
 ALARM TIME: 0unit (disabled)
 START UP DELAY: 0 sec
DEFAULT SETTINGS RESTORE
PUMP'S CONNECTION
Rev 1.0
1.Display LCD 8 x 2 backlight
2.Green Led: ▪ fix = PUMP ON
3.Red Led: indicates the injections
4.CAL button : ▪ allows to enter in programming
5/6. – and + buttons : ▪ allows to navigate through the menu
7. ESC/SBY button: ▪ puts the pump in stand_by mode
type Rx:
 FUNCTIONING: Prop
 SETPOINT: 730mV
 DIRECTION DOSING: Oxid
 INJECTION FREQUENCY: 100% (150 imp/min)
 ALARM TIME: 0unit (disabilitato)

START UP DELAY: 0 sec
Push and quickly release CAL button and then pressing + and – buttons
select "Restore Enter"
Push CAL to confirm the choice. The pump goes back in measure restoring
in memory the default settings and calibrations parameters.
A – Power cable, 230 V- 50Hz (upon request : 115 ~ )
B – Level probe connector (3 and 4 contacts). OPTIONAL
C – Flow sensor connector (3 and 4 contacts). OPTIONAL
D - BNC connector for pH or Orp(Rx) probe.
E - ON_OFF switch. OPTIONAL
Cod. 00.008.254
▪ blinking = PUMP IN ALARM
▪ saves the changes
▪ Modify the parameters values
▪ allows to exit the menu
9